MeasureOver

Making a stencil from a photograph

A stencil only works if the shapes sit in the right place relative to each other. Guide lines fix those positions before anything is cut, and the 300 DPI export gives you a sheet to cut straight from.

Works well with

  • A high-contrast photo — strong light, few mid-tones
  • A silhouette or logo
  • A portrait already reduced to two or three tones

What you get

  • A printed sheet with guide lines for positioning the cut shapes
  • Measured coordinates for marking stencil material by hand

Reduce before you measure

A stencil is a two-tone object. Work out which areas are cut and which are left before placing a single guide line — grayscale and contrast help here, because they make it obvious where a mid-tone is going to have to commit one way or the other.

Position the shapes, not the outlines

The instinct is to trace edges. For a stencil what matters is where each shape sits relative to its neighbours: a mouth two millimetres low reads as a different face. Put your guide lines through the anchors — eye corners, the centre line, the outer bounds — and let the outlines follow.

Bridges are structure

Anywhere an island would float free needs a bridge, and bridges are easier to plan on screen than to rescue mid-cut. Mark them as guide lines so their positions transfer with everything else.

Open MeasureOver

Questions

Should I turn on the grid for stencil work?
Usually yes. A stencil is mostly about repeated positioning, and a grid gives you a consistent reference across the whole sheet rather than only at the points where your guide lines happen to cross.
How do I keep bridges in the right place?
Place a guide line along each bridge before cutting. The bridge positions then come across as measurements like everything else, which matters because a bridge in the wrong place is what makes a stencil fall apart.
What paper size should I use?
Whatever the finished stencil needs to be. Set that first — the coordinates are calculated against it, so measuring on A4 and cutting on A3 will put every shape in the wrong place.
Can I cut directly from the exported sheet?
Yes. The export is 300 DPI with the guide lines drawn in, so printing it at the chosen paper size gives you a full-scale template to spray-mount onto stencil material.